TM 5-6675-325-14
NOTE
Over-tension of rollers will slow motor down and possibly wrinkle paper
edge even though paper remains centered on rollers.
j .
Adjust both screws one full turn to the
k. Push PRINT switch and
r o l l e r s .
Readjust if
left to reduce tension.
observe that paper is driven correctly by
required.
l .
Pull enough paper, approximately 24 in. (61 cm), from stock roll to
produce free loop.
Avoid kinks or wrinkles in paper.
m.
Cycle reader-printer through five long prints. Observe paper for
even tracking and disregard any side-to-side movement of less than
.12 in. (3mm).
Reader-printer should produce five long prints
without mistracking.
Readjust if required.
n.
Reinstall rear paper loading door.
o.
Run five long prints to clear exposed paper from reader-priter.
3-76
