TM 5-6675-325-14
2-11. LUBRICATION
Section IV ORGANIZATIONAL MAINTENANCE
INSTRUCTIONS.
2-11.1 Pillow Block Fittings.
After replacement, apply ball and roller bearing
grease to pillow blocks (paragraph 2-8.1).
2-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIP-
MENT (TMDE); AND SUPPORT EQUIPMENT.
2-12.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
2-12.2 Special Tools: Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
2-12.3 Repair Parts.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-325-24P covering organizational maintenance for
this equipment.
2-13. SERVICE UPON RECEIPT.
ceived mounted in the section
The drafting, scribing/tracing table may be re-
or in a shipping crate.
2-13.1 Checking Unpacked Equipment.
a.
Inspect the equipment for damage incurred during shipment. If equipment has
been damaged, report the damage on DD Form 6, Packing Improvement Report. -
b. Check the equipment against the packing list to see if the shipment
complete.
Report all discrepancies in accordance with the instructions of
DA Pam 738-750.
c.
Check to see whether the equipment has been modified.
2-14. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES.
no organizational PMCS procedures assigned for this equipment.
is
There are
2-15