TM 5-6675-325-14
2-6. OPERATION UNDER USUAL CONDITIONS.
2-6.1
Assembly and Preparation for Use.
a.
Clean work surface.
b. Plug power cord into electrical receptacle.
c.
Turn power switch on for light table use.
2-6.2 Operating Procedures.
a.
Changing Work Surface.
CAUTION
Safety stops have been included to prevent overtravel of table top and
damage to electrical wiring.
If drafting surface is in top position,
swing front edge of table top down to change work surface.
If l i g h t
table is in top position, swing front edge up to change work surface.
Table cannot be rotated until cabinet assembly is swung out.
(1) Pull cabinet assembly lock release ring and swing out cabinet assembly.
(2) Loosen tilt lock until it clears table top assembly.
(3) Tighten tilt lock to secure table top assembly in position.
(4) Return cabinet assembly to its normal position under table top assembly.
(5) Press firmly on cabinet assembly front until cabinet assembly lock
clicks.
2-6.3 Preparation for Movement.
a.
Turn off power.
b. Unplug power
c.
Rotate table
upward.
d. Tighten tilt
e.
Press firmly
cord.
Coil power cord and tape to table.
top assembly, if necessary, to be sure glass surface faces
lock to secure table top assembly.
on cabinet assembly front until cabinet assembly lock clicks.
f. Check cabinet drawers for open containers and loose items. Seal containers
and secure all loose items.
g.
Lock cabinet drawers.
2-7. OPERATION UNDER UNUSUAL CONDITIONS. This equi
operation only in a controlled environment.
pment is designed for
2-11