TM 5-6675-324-14
e.
Loosen setscrew and remove bushing from handle shaft.
f.
Remove handle retaining screws and remove handle.
Install new handle and secure with screws.
g.
h.
Reinstall bushing on handle shaft and tighten setscrew.
i.
Reinstall handle retaining nut.
Install side latch plate.
j.
k.
Reinstall latch rod holding plates and latch rods.
l.
Reinstall holding plate retaining nut.
MOS:
83FJ6, Reproduction Equipment Repairer
TOOLS :
1/4 in. Electric Drill
5/32 in. Drill Bit
Pop Rivet Gun
Storage Cabinet Hinge
SUPPLIES:
5/32 in. Pop Rivets
8-32 x 1/2 in. Screws (4 required)
8-32 Nuts (4 required)
a.
Drill out rivets holding hinge to cabinet and remove hinge.
b.
Install new hinge and temporarily secure with four screws and nuts.
c.
Close and latch cabinet door and install pop rivets.
d. Remove temporarily installed screws and nuts, and install pop rivets.
MOS: 83FJ6, Reproduction Equipment Repairer
PERSONNEL: Two persons are required to perform this procedure.
Flat Tip Screwdriver
TOOLS:
Pop Rivet Gun
Drill and Bits
SUPPLIES: Map and Plan Filing Cabinet
Pop Rivets
Portable Drawing Board
9-8
