TM 5-6675-324-14
(d) Plug power transformer cable into wall outlet.
(e) Plug power cord into back of calculator.
(f) Plug power cord into wall outlet.
(9) Set encoder 0FF/E2/E1 switch on back panel of auto-scaler to E1.
(h) Set AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
(i) Set auto-scaler B/ACCU/A/OFF switch to ACCU.
(J) set auto-scaler MAN/AUTO switch to AUTO.
(k) Set auto-scaler X MEMORY switch to 1.
(1) Set calculator OFF/ON switch to ON.
(m) Set calculator MAN/TRACE/NORM switch to MAN.
(n) Set calculator PRGM/RUN switch to RUN.
(o) Press following keys:
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil, or
other materials may damage magnetic cards.
(3) Load preprogrammed magnetic card (paragraph 5-6.2.10), Program IV, into
calculator.
(4) Tape photograph to be measured to table.
(5) If needed, aline li near measuring probe (paragraph 5-6.2.16). Record RL
value.
NOTE
provided with equipment. Alinement is performed as a check.
(6) Press CLEAR button to clear auto-scaler.
5-83
