TM 5-6675-324-14
CAUTION
q Do not allow photosensitive drum to touch gear shaft. Gear shaft may
touch drum and contaminate it, rendering it useless.
To prevent gear damage, the drum should be pushed to front of machine.
NOTE
Store removed drum in a place away from direct sunlight, dust, ammonia,
or anything that might scratch surface.
q If drum surface is scratched, the drum must be replaced.
After drum replacement, corona wires should be set to specifications
as indicated on panel inside front door.
e.
Clean and install new photosensitive drum in drum cradle.
f. Lower and latch upper assembly.
Reinstall drum shaft.
g.
h. Position securing plate in groove in shaft and tighten screw.
i.
Raise upper assembly to full open position.
j. Manually rotate drum to the left until it stops. Avoid touching the
yellow portion of the drum.
k. Close the upper assembly.
1.
Raise blade lever and position in groove in drum shaft.
m.
Close front door.
n.
Plug in power cord.
o.
Turn power switch to 1 (ON).
3-251