TM 5-6675-324-14
Measure distance from top of RS1 to bottom of magnet. Distance
k.
should be 4.00.5tmn (0.16 in. O.02 in.). Adjust as necessary.
Check that platen is to left as viewed from rear.
1.
Multimeter should indicate O ohms.
m.
Multimeter should indicate infinity.
Move platen to home position.
n.
Remove test leads.
o.
Repeat steps i thru p for RS2 thru RS4. Check points and meter
P*
indications as listed in above figure.
Remove lower rear panel.
q.
r.
Disconnect J6 and J304 located at rear of fixing assembly.
3-175
