TM 54675-324-14
3-20.17 Adjust Stro k of Blank Exposure S butter,
e
MOS: 35E, Special Electronic Devices Repairer
TOOLS: No. 2 Cross Tip Screwdriver
1/8 in. x 2-1/2 in. Flat Tip Screwdriver
1/4 in. x 4 in. Flat Tip Screwdriver
7 mm Combination Wrench
Machinist's Rule
SUPPLIES: Rubber Matting
WARNING
Electrical shock hazard. You must stand on rubber matting as a protective
measure before performing this procedure. Death or serious injury could
result.
a.
Turn power switch to O (OFF).
b. Open front door.
c.
Loosen bolt and measure distance from front side plate to adjusting
plate bracket.
d. Adjust bolt to obtain clearance of 70.5mm (0.28 in. 0.02 in.).
e.
Close front door and turn power switch to 1 (ON).
f. Load cassette.
Place NA test sheet on platen.
9*
3-172
