TM 5-6675-324-14
h. When WAIT/STANDBY indicator stops flashing, make copy counter read 10.
Press COPY START key.
i.
j. Measured width of clear area should be 6 to 7.5 mm (0.23 in. to
0.29 in.).
k. Readjust as necessary.
1.
Turn power switch to 0 (OFF).
3-20.18 Replace Reed Sw i t c h
MOS: 35E, Special Electronic Devices Repairer
TOOLS: No. 2 Cross Tip Screwdriver (8 in.)
Machinist's Rule
SUPPLIES: Reed Switch
Contact Socket
Jumper Wire
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
a. Turn power switch to O (OFF).
b. Unplug power cord.
c.
Slide platen to right.
d. Raise upper assembly to full open position.
e.
Remove upper rear panel.
3-173
