TM 5-6675-324-14
Table 1-2. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
NO ELECTRICAL POWER TO SECTION - Cont
Step 4.
Check main circuit breaker position.
(a) If circuit breaker is ON, refer to direct/general support
maintenance.
(b) If circuit breaker is OFF, turn ON.
(c) If circuit breaker trips repeatedly, notify power supply
supervisor.
2. NO ELECTRICAL POWER TO EQUIPMENT.
Step 1.
Check equipment power switch.
(a) If power switch is ON, proceed to step 2.
(b) If power switch is OFF, turn ON.
Step 2.
Check power cord.
(a) If power cord is plugged in, proceed to step 3.
(b) If power cord is unplugged, plug in.
Inspect circuit breaker panel for breakers in OFF position.
Step 3.
(a) If al 1 circuit breakers are ON, refer to direct/general
support maintenance.
(b) If any circuit breakers are OFF, turn ON.
1-47
