TM 5-6675-323-14
16-10. MAINTENANCE PROCEDURES.
There are no operator maintenance procedures
assigned for this equipment.
Section IV ORGANIZATIONAL MAINTENANCE
This equipment does not require lubrication.
LUBRICATION INSTRUCTIONS.
1 6 - 1 2 . REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
F o r authorized common tools and equipment,
16-12.1 Common Tools and Equipment.
r e f e r to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
1 6 - 1 2 . 2 Special Tools; Test. Measurement, and Diagnostisc Equipment; and Support
S p e c i a l Tools, TMDE, and Support Equipment is listed in the applicable
Equipment.
repair parts and special tools list and in Appendix B of this manual.
Repair parts are listed and illustrated in the Repair Parts
16-12.3 Repair Parts.
a n d Special Tools List, TM 5-6675-323-24P covering organizational maintenance for
this equipment.
SERVICE UPON RECEIPT.
16-13.1 C h e c k i n g U n p a c k e d E q u i p m e n t .
a. Inspect the equipment for damage incurred during shipment. If equipment has
b e e n damaged, report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
Report all discrepancies in accordance with the instructions of DA Pam
complete.
738-750.
C h e c k to see whether the equipment has been modified.
c.
1 6 - 1 4 . ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND
SERVICES. There are no
organizational PMCS procedures assigned for this equipment.
ORGANIZATIONAL TROUBLESHOOTING PROCEDURES.
16-15.
a. Organizational troubleshooting procedures cover the most common malfunctions
Repair or adjustment requiring
that may be repaired at the organizational level.
specialized equipment is not authorized unless such equipment is available.
Troubleshooting procedures used by the operator should be conducted in addition to
the organizational troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible
If a malfunction is not listed or is not
test/inspection and corrective action.
corrected by a listed corrective action, notify your supervisor.