TM 5-6675-323-14
(c) PIug power transformer cable into POWER supply jack on back panel of
auto-scaler.
(d) Plug power transformer cable into wall outlet.
(e) Plug power cord into back of calculator.
(f) Plug power cord into wall outlet.
(9) Set encoder 0FF/E2/E1 switch on back panel of auto-scaler to E2.
(h) Set AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
(i) Set auto-scaler B/ACCU/A/OFF switch to A.
( J ) Set auto-scaler MAN/AUTO switch to AUTO.
( k ) Set auto-scaler X MEMORY switch to 1.
(l)
Set
c a l c u l a t o r OFF/ON switch to ON.
( m ) S e t c a l c u l a t o r MAN/TRACE/NORM switch to MAN.
(n)
Set
c a l c u l a t o r PRGM/RUN switch to RUN.
(o)
Press
following
keys:
and
,
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil, or
o t h e r materials may damage magnetic cards.
( 3 ) Load preprogrammed magnetic card (paragraph 9-6.2h), Program IV, into
calculator.
(4) Tape photograph to be measured to table.
(5) Select correct tracer arm length.
NOTE
Tracer arm length should be shortest one possible that will allow entire
shape to be measured without moving the planimeter.
(6) Aline planimeter with tracer arm length selected (paragraph 9-6.2k).
R e c o r d RT v a l u e .
9-85
