TM 5-6675-323-14
(e)
Plug power transformer cable into wall outlet.
(f)
Plug power cord into back of calculator.
Plug power cord into wall outlet.
(g)
(h)
S e t e n c o d e r O F F / E2 / E1 s w i t c h o n b a c k p a n e l o f a u t o - s c a l e r t o
(i)
S e t AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
S e t auto-scaler B/ACCU/A/OFF switch to A.
(j)
(k)
S e t auto-scaler MAN/AUTO switch to MAN.
(l)
S e t auto-scaler X MEMORY switch to 1.
( m ) S e t c a l c u l a t o r OFF/ON switch to ON.
(n)
Set
c a l c u l a t o r MAN/TRACE/NORM switch to NORM.
(o)
Set
c a l c u l a t o r PRGM/RUN switch to RUN.
(p)
Press
following
keys:
,
,
and
.
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil,
o r other materials may damage magnetic cards.
( 3 ) Load preprogrammed magnetic card (paragraph 9-6.2h), Program II, into
calculator.
(4) Tape map or drawing to be measured to table.
(5) Select correct tracer arm length.
NOTE
Tracer arm lenqth should be shortest one possible that will allow entire
shape to b e m e a s u r e d w i t h o u t m o v i n g t h e p l a n i m e t e r .
(6)
If n e e d e d , a l i n e p l a n i m e t e r w i t h t r a c e r a r m l e n g t h s e l e c t e d ( p a r a g r a p h
9-6.21).
9-79
