TM 5-6675-323-14
SECTION V DIRECT/GENERAL SUPPORT MAINTENANCE
8-18.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
8-18.1 Common Tools and Equipment.
F o r authorized common tools and equipment,
r e f e r to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
8 - 1 8 . 2 Special Tools: Test, Measurement. and Diagnostic Equipment; and Supprt.
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
8-18.3 Repair Parts. Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-323-24P covering direct/general support mainte-
nance for this equipment.
a.
Direct/general support troubleshooting procedures cover the most common
malfunctions that may be repaired at the direct/general support level. Repair or
adjustment requiring specialized equipment is not authorized unless such equipment
i s a v a i l a b l e . Troubleshooting procedures used at lower levels should be conducted
in addition to the direct/general support troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible
test/inspection and corrective action.
If a malfunction is not listed or corrected
by a listed corrective action, notify your supervisor.
For unidentified malfunctions, use the following schematic or the foldout
located at the end of this manual for further fault analysis.
d.
If the zoom transfer scope does not power up when turned on, verify that
120 V ac is present at the receptacle.
If voltage is not present, plug equipment
into receptacle with power available and proceed with equipment troubleshooting.
Perform no-power procedures for dead receptacle (Table 1-4).
