TM 5-6675-323-14
Function
Control
or
Indicator
O p t i c a l Mount Rotation Lock
Locks inner ring to allow
m o u n t e d optics to be rotated
and locked.
M o m e n t a r y Switch
Uncouples electrical
clutches, permitting rapid
m o v e m e n t of optical mount in
X or Y direction.
S t a g e Separation Knob
M o v e s left view stage to
permit access to center film
rollers.
Grid Intensity Control
Increases or decreases light
intensity for both right and
left light grids.
M a i n Power Switch
Controls power to table.
a. Before You Operate.
Always keep in mind the WARNINGS and CAUTIONS. Perform
y o u r before (B) PMCS.
b. While You Operate.
Always keep in mind the WARNINGS and CAUTIONS. Perform
y o u r during (D) PMCS.
c.
A f t e r You Operate.
B e sure to perform your after (A) PMCS.
d.
I f Your Equipment Fails to Operate. T r o u b l e s h o o t w i t h p r o p e r e q u i p m e n t .
Report any deficiencies using the proper forms. See DA Pam 738-750.
PMCS Procedures.
6-5.1
P M C S are designed to keep the equipment in good working condition by
a.
performing periodic service tasks.
b. Service intervals provide you, the operator, with time schedules that
determine when to perform specified service tasks.
c . The "Equipment is Not Ready/Available If" column is used for identification of
conditions that make the equipment not ready/available for readiness reporting
purposes or denies use of the equipment until corrective maintenance is performed.
If your equipment fails to operate after PMCS is performed, immediately report
d.
this condition to your supervisor.
6-10
