TM 5-6675-323-14
(o) Using dynamometer, push cable at midpoint until it just
touches rear track edge.
Pull cable at loop crimp terminal
until cable tension of about 300 grams is obtained on gage.
S e c u r e l y crimp loop crimp terminal to cable and cut off excess
cable.
(14) Adjust cable tension for 325 + 25 g. Refer to cable tension
adjustment procedure (paragraph 3-29.3).
(15) Lower upper deck assembly and reinstall rear hood.
3-29.18 HP-IB Logic Board Replacement.
MOS:
35E, Special Electronic Devices Repairer
TOOLS :
C r o s s Tip Screwdriver (No. 1)
SUPPLIES:
PCA Assembly
a.
O n side of PCA enclosure with dimple, remove two screws shown.
b . Turn PCA enclosure over and remove four screws shown.
c.
Grasp both sides of PCA enclosure and carefully pull them apart.
3-306
