TM 5-6675-323-14
(2) Raise upper deck.
Swing latching bar up and engage it securely
in retaining slot.
c.
M o v e the arm assembly to the extreme right side of its travel as viewed
from the front of the plotter.
Position the pen claw so that it just
touches the right end of the pen capper assembly of stall #8.
d. Connect a multimeter across X-limit switch connector located on the
front panel PCA.
Adjust the switch bracket until the switch just
closes.
Tighten the adjustment screw and reinitialize the plotter to
check the adjustment.
Repeat if necessary.
3-260
