TM 5-6675-323-14
Table 3-20. PLOTTER PROGRAMMING LANGUAGE - Cont
S t a t e m e n t Identification and Use
Program
S t a t e m e n t , Syntax, Explanation, and Input Instructions
Statement
dig - Cont
NOTE
Select code for plotter is set at factory to 705.
variable 1
X-coordinate value
variable 2
Y-coordinate value
p e n status
parameter
(0 = Up, 1 = Down)
(If
Specified)
To cancel digitize statement without entering values, press
If digitize statement is executed from program,
STOP key.
S T O P key will also stop program at end of line containing
digitize statement.
Special digitizing sight is provided with plotter. This allows
you to visually position pen directly over point to be digi-
tized.
Sight is loaded and stored like pen.
NOTE
If more than one point is to be digitized, then pro-
g r a m must contain looping statements to return to and
r e p e a t program step containing digitize command or con-
tain several digitize commands. Plotter can only digi-
tize one point each time digitize command is encountered.
wrt
WRITE.
Identifies additional plotter control commands.
Syntax:
wrt 705, command code
NOTE
Select code for plotter, set at factory, is 705.
S y n t a x and function of control commands o n next page.
3-200
