TM 5-6675-323-14
d.
Press LINE power switch on front base of plotter. Plotter should respond as
follows:
(1) Pen raises.
(2) Pen moves to lower right corner of platen.
3 - 1 5 . 2 I n i t i a l A d j u s t m e n t s , D a i l y C h e c k s , a n d Self Test.
a.
Confidence
test.
(1) Turn LINE power switch off (0).
(2) Connect power cables.
(3)
Disconnect
interface
cable
at
plotter.
( 4 ) Flip LISTEN ONLY switch to 0.
( 5 ) Flip CONFIDENCE TEST switch to 0.
( 6 ) Set Logic ADDRESS switches to I0I00.
(7)
Initialize
plotter:
(a) Press LINE power switch on.
( b ) Press CHART LOAD button.
(c) Press ENTER button.
(d) Place paper on platen.
( e ) Press CHART HOLD button.
(8) Install pen in pen arm.
(9) Turn CONFIDENCE test switch to I. After completion of plot, pen should
stop in lower left corner of platen and all lamps on front panel should be turned
on.
(10) Press PEN UP button. Remove pen.
3-158
