TM 5-6675-323-14
3-15. OPERATION UNDER USUAL CONDITIONS.
In general, independent operation of the
plotter is confined to self testing and editing charts. All other operating proce-
dures use a computer to control the operation of the plotter, using programs written
by the operator and inputted through the computer.
3-15.1 Assembly and Preparation for Use.
a.
Plug female end of power cord into jack on rear panel of plotter.
WARNING
Death or serious injury may occur from electrical shock. Plotter is
equipped with three-conductor power cable which grounds plotter. Do
n o t operate plotter from ac outlet that does not have connected ground
pin.
CAUTION
B e sure power is off before plugging ROM's or interface cable into
e q u i p m e n t , or damage to equipment will result.
b. Plug male end of power cord into grounded ac outlet.
Plug one end of interface ROM in rear of computer. Connect other end of
c.
interface into jack on rear panel of plotter. Tighten knurled screws to fasten
connection.
3-157
