TM 5-6675-321-14
4-6.2 Operating Instructions on Decals and Instruction Plates.
OPERATING
S T A RT
MACHINE MUST BE ON A LEVEL SURFACE.
PLUG THE POWER LINE CORD INTO AN
A.C. GROUNDED OUTLET. THE SWITCH ON
THE LEFT HAND SIDE CONTROLS THE
HEATER TO MELT THE WAX. THE RED,
ADJACENT PILOT LIGHT WILL GLOW WHEN
THIS SWITCH IS ON. IN APPROXIMATELY
20 MINUTES THE AMBER LIGHT WILL
GLOW, INDICATING THAT THE WAX IS AT
OPERATING TEMPERATURE. THE MACHINE
IS THEN READY FOR USE. THROW THE
RIGHT HAND SWITCH “ON” TO ACTIVATE
THE MOTOR AND COATING ROLLER. (NOTE:
MOTOR WILL NOT OPERATE UNTIL THE
AMBER LIGHT GOES ON.
MODEL 1215
A. C. VOLTS 120
SER. NO. IZ 787
W A T T S 6 5 0
INSTRUCTIONS
U S E
WITH MOTOR RUNNING, PLACE MATERIAL
TO BE COATED ON THE DECK OF THE
MACHINE WITH PRINTED MATTER FACE UP
GENTLY PUSH MATERIAL FORWARD UNTIL
IT IS CAUGHT BY THE ROLLERS. ADHESIVE
wAX COAT WILL BE APPLIED AS MATERIAL
PASSES THROUGH THE MACHINE. TURN
OFF MOTOR SWITCH AFTER PROCESSING
MATERIAL. HEATER SWITCH SHOULD BE LEFT
ON DURING THE DAY WHILE MACHINE IS
IN USE.
C A R E
KEEP WAX LEVEL UP TO THE MARKER
ADD WAX WHEN NECESSARY. DO NOT
MOVE MACHINE WHILE WAX IS HOT. SET
HI-LO THERMOSTAT CONTROL AT MID-POINT
UNLESS IT IS DESIRED TO HAVE WAX AT
HIGHER OR LOWER TEMPERATURE. FOR
ADJUSTMENTS AND FURTHER INSTRUCTIONS
SEE MANUAL.
WARNING: MACHINE WILL NOT OPERATE PROPERLY
UNLESS WAX LEVEL IS UP TO THE MARKER IN TRAY
• DO NOT MOVE MACHINE WHILE WAX IS LIQUID•
FOR ACCESS TO REAR SECTION OF TRAY AND UNDERSIDE OF DRUM
CARRIAGE MAY BE TILTED UPWARD WHEN WAX IS MELTED BY GRASPING ROD
RUNNING ACROSS REAR OF MACHINE (USE GLOVE) AND PULLING UPWARD
SEVERAL INCHES. THE CARRIAGE SUPPORT BAR, INDICATED BY ARROW BE-
LOW, WILL SWIVEL INTO A VERTICAL POSITION TO HOLD THE CARRIAGE UP-
RIGHT AT AN ANGLE.
TO RETURN CARRIAGE TO THE OPERATING POSITION,
GRASP REAR ROD, ROTATE SUPPORT BAR TO ITS ORIGINAL ANGULAR POSl-
TION AND SLOWLY LOWER CARRIAGE INTO TRAY.
4-7.
OPERATION
operation only in
4-26
UNDER UNUSUAL CONDITIONS.
This equipment is designed for
a control led environment.
