TM 5-6675-320-14
(c) Securely crimp the cable terminal and cut off the excess.
(d) Remove all tape from motor and pulleys.
(e) Remove nuts from pen holder assembly.
( f ) R e i n s t a l l t r a i l i n g c a b l e t e r m i n a t i o n b r a c k e t o v e r t h r e a d ed
s t u d s . R e i n s t a l l n u t s a n d t i g h t e n .
(g) Position pen solenoid wires so that they will not rub on
p u l l e y s.
( h ) R e i n s t a l l t r a i l i n g c a b l e t r a y c o v e r . C h e c k e n d s f o r f l u sh
f i t .
CAUTION
Do not touch dashpot piston with bare hands. Skin oils will damage surface
o f p i s t o n .
(i) Reinstall dashpot assembly. Hook end of pistion into notch and
position spring over pin. If piston becomes separated from
dashpot, do not touch with bare hands .
(j) Position upper pen holder and install screw.
(k) Reinstall pen holder cover and install screw.
( l ) P o s i t i o n p l o t t e r a r m a t t h e l e f t ( p e n s t a l l ) e n d o f p l o t t e r.
(m) Position pen carriage assembly at top right corner of platen.
( n ) P u l l o n l o o s e c a b l e a t l o o p c r i m p t e r m i n a l u n t i l a l l s l a c k is
gone from cable.
Locate midpoint between two pulleys on Y-
a x i s c a b l e.
4-305
