4-29.18
(14)
(15)
( o ) U s i n g d y n a m o t e r , p u s h c a b l e a t m i d p o i n t u n t i l i t j u st
touches rear track edge.
Pull cable at loop crimp terminal
until cable tension of about 300 grams is obtained on gage.
Securely crimp loop crimp terminal to cable and cut off excess
c a b l e.
Adjust cable tension for 325 + 25 g. Refer to cable tension
adjustment procedure (paragraph 4-29.3).
Lower upper deck assembly and reinstall rear hood.
HP-IB Iogic Board Replacement.
M O S : 3 5 E , S p e c i a l E l e c t r o n i c D e v i c e s R e p a i r er
TOOLS: Cross Tip Screwdrive (No. 1)
SUPPLIES:
PCA Assembly
CARD ENCLOSURE
a.
On side of PCA enclosure with dimple, remove two screws shown.
b. Turn PCA enclosure over and remove four screws shown.
c .
Grasp both sides of PCA enclosure and carefully pull them apart.
4-306
TM 5-6675-320-14
