TM 5-6675-320-14
Table 4-22.. TROUBLESHOOTING - Cont
TEST OR INSPECTION
8.
9 .
10.
11.
12.
NO MOVEMENT IN “Y” DIRECTION.
P r o b l e m i s n o t o p e r a t o r c o r r e c t a b l e . R e f e r p l o t t e r t o d i r e c t / g e n e r a l s u p p o rt
t r o u b l e s h o o t i n g .
PLOTTER INITIALIZES, THEN CONTINUES TO DRIVE, WHILE IN (LOWER RIGHT) STOPS.
P r o b l e m i s n o t o p e r a t o r c o r r e c t a b l e . R e f e r p l o t t e r t o d i r e c t / g e n e r a l s u p p o rt
t r o u b l e s h o o t i n g.
PEN SKIPS WHILE PLOTTING.
Problem is not operator correctable. Refer to direct/general support
t r o u b l e s h o o t i n g.
PLOTTER PERFORMS ABNORMALLY OR ERRATICALLY.
Problem is not operator correctable. Refer to direct/general support
t r o u b l e s h o o t i n g .
PLOTTER DOES NOT DRAW EXPECTED PLOT OR PLOT APPEARS INACCURATE.
Step 1.
Check program for incorrect or misplaced syntax.
(a) If program is correct, proceed to step 2.
( b ) R e - e n t e r c o r r e c t p r o g r a m s e q u e n c e .
Step 2.
Perform operator’s HP-IB operational test (paragraph 4-14.2) .
I f p r o b l e m p e r s i s t s , r e f e r p l o t t e r t o d i r e c t / g e n e r a l s u p p o rt
t r o u b l e s h o o t i n g.
4-220
