TM 5-6675-320-14
Table 4-22. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. PLOTTER STOPS. COMPUTER DISPLAYS ERROR MESSAGE.
Refer to Table 4-21, Plotter Operation and Program Errors, for corrective
(a) Re-enter program using correct key sequence.
(b) If problem persists, refer to direct/general support
maintenance.
3.
COOLING FAN RUNS. EVERYTHING ELSE IS INOPERATIVE.
Press LINE power switch to off (0) and then to on (I).
NOTE
This action resets power supply if fault was caused by momentary low line
v o l t a g e .
If problem persists, refer to direct/general support maintenance.
4. PLATEN DOES NOT HOLD PAPER WHEN “CHART HOLD” IS ACTIVATED.
Step 1.
Check that paper is not wet and platen is clean.
(a) If paper is not wet and platen is clean, proceed to
Step 2.
( b ) C l e a n p l a t e n i f n e c e s s a r y.
( c ) R e p l a c e p a p e r .
Step 2.
Press LINE power switch to off (0) and then to on (I).
If problem persists, refer to direct/general support maintenance.
4-218
procedure.
