TM 5-6675-320-14
(8) After program is written, set computer in program mode and input each
line of program and any data by keying in complete statement and then pressing
STORE .
( 9 ) W h e n e n t i r e p r o g r a m i s e n t e r e d , p l a c e c o m p u t e r i n r u n m o d e a n d p r e ss
Certain programming
Among these are:
p o i n t .
l e n g th
Select pen before
NOTE
p r a c t i c e s w i l l a s s u r e m o r e e f f e c t i v e u s e o f p l o t t e r.
first plot command to assure plot is actually
recorded on paper.
Lift pen before changing colors to avoid a dot of new color at termination
o f l a s t v e c t o r .
Store pens at completion of plot so pens do not dry out.
When using A4 or 8-1/2 in. X 11 in. paper, reset P1 and P2 manually or
programmatically to points inside paper area. Default P2 will scale
plot beyond limits of 8-1/2 in. X 11 in. paper .
C h a r t e d i t i n g.
( 1 ) I n i t i a l i z e p l o t t e r .
(2) Load chart to be edited .
( 3 ) L o a d p e n s o f d e s i r e d c o l o r s i n t h e i r s t a l l s .
(4) Straight lines can be added by moving pen with pen controls to start
Press PEN DOWN and move pen in direction desired with controls until line
d e s i r e d i s d r a w n.
(5) To add curved lines or labels, construct program to draw desired figure
o r l a b e l.
NOTE
Be sure to set scale of plotter to that of chart being edited, and
instruct plotter exactly where change or addition is to be made.
4-74
RUN.
g.
