TM 5-6675-320-14
d . H P - I B o p e r a t i o n a l t e s t.
WARNING
Death or serious injury may occur from electrical shock. Plotter is
equipped with three-conductor power cable which grounds plotter .
Do not
operate plotter from ac outlet that does not have connected ground pin.
CAUTION
Be sure power is off before plugging HP-IB ROMs or HP-IB Interface cable
into equipment or damage to equipment will result.
(1) Turn off computer power.
Plug HP-IB card into I/0 slot in back of
computer.
(2) Plug plotter extended and general I/0 ROM into slot in front of
computer.
( 3 ) T u r n o n c o m p u t e r . V e r i f y l a z y t ee
NOTE
If lazv tee does not smear, remove HP-IB
display is on computer.
Interface and press RESET. If
it stiil does not appear, troubleshoot computer.
(4) Enter program line shown below.
PROGRAM LINE:
rds (7,A,B,C)~D; dst A,B,C,D
(5) Press EXECUTE and verify that display shown above appears.
(6) If display does not return after line is executed, press RESET and
rotate HP-16 Interface select code switch to O, then back to 7, carefully with a
s c r e w d r i v e r.
( 7 ) R e p e a t s t e p ( 4 ).
( 8 ) I f d i s p l a y d o e s n o t r e t u r n o r d i s p l a y i s i n c o r r e c t , c a r d i s d e f e c t i v e.
4 - 65
