B - Before
D - During
A - After
ITEM
NO.
1
lN-
TER-
VAL
S
Table 9-3. ORGANIZATIONAL PREVENTIVE MAINTENANCE
W - Weekly
AN - Annually
M - Monthly
S
- Semiannually
Q - Quarterly
BI - Biennially
ITEM TO BE INSPECTED
PROCEDURE
TM 5-6675-319-14
CHECKS AND SERVICES - Cont
(Number) - Hundreds of Hours
CONTACT PRINTER/ENLARGER - Cont
Service Printer - Cont
15.
Check that all parts are securely fastened.
16.
Check that insulation and wiring are not damaged
or broken.
17.
Check that wiring is not stretched between ter-
minals or around sharp corners.
18.
Reinstall RPT rear cover and secure by tighten-
ing screws.
19.
R e p o s i t i o n p r i n t e r / e n l a r g e r o v e r a i r s h o c k s , r a i se
casters, and reinstall bolts and washers.
20.
Turn on circut breaker.
9-15. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES.
a. Organizational troubleshooting procedures cover the most common malfunctions
that may be repaired at the organizational level.
Repair or adjustment requirin g
specialized equipment is not authorized unless such equipment is available.
Troubleshooting procedures used by the operator should be conducted in addition to
the organizational troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible test/
inspection and corrective action.
I f a m a l f u n c t i o n i s n o t l i s t e d o r i s n o t
c o r r e c t e d b y a l i s t e d c o r r e c t i v e a c t i o n , n o t i f y y o u r s u p e r v i s o r .
c. For unidentified malfunctions, use the facing schematic or the foldout
located at the end of this manual for further fault analysis.
d.
If the contact printer enlarger does not power-up when turned on, verify that
120 V ac is present at the receptacle.
If voltage is not present, plug equipment
into receptacle with power available and proceed with equipment troubleshooting.
Perform no-power procedures for dead receptacle (Table 1-4).
9-77
