TM 5-6675-319-14
of the run/stop flip-flop and the reset network.
T h i s i n h i b i t s t h e r u n / s t o p f l i p -
flop and reset network and allows the slow axis integrator to recycle continuously
so that the CRT will display a well-defined raster.
(7) The manual mode of operation is selected by setting MODE switch S103 to
MAN. The manual mode is used when it is desired to make an undodged printout of a
dodged negative.
The dodging circuit output is grounded through MODE switch S103.
The fast axis integrator is driven at a fixed rate by the gating circuit on card
3C2. The manual mode is not used when processing aerial film.
Section II
OPERATING INSTRUCTIONS
9-4. DESCRIPTION AND USE OF OPERATOR’S CONTROLS AND INDICATORS.
9-4.1
Power Control Panel.
9-17
