TM 5-6675-318-14
The functional diagram shows the standard mode of operation. The 3D positioning
computation will provide location data of the survey site with an accuracy within 10
m (32.8 ft) rms.
Assemble and prepare the equipment for use (paragraph 4-6.1 and
4-6.2) and operate the receiver/processor in the standard mode as follows:
a. Select the standard mode of operation by entering code 10. If necessary,
press change sign (+/-) key until standard mode is displayed and press enter (E) key.
b .
If a print-out is desired, activate the printer in accordance with paragraph
4-6.2.1, page 4-58.
c .
I f n o t p r e v i o u s e n t e r e d , e n t e r t h e s u r v e y s i t e l o c a t i o n e s t i m a t e a n d a l e r t
data (paragraph 4-6.2c, page 4-7).
d.
I n s t a l l a b l a n k t a p e c a s s e t t e a n d p o s i t i o n a t B O T u s i n g c o d e 4 1 , to
record pass data as it become available.
e.
NOTE
If 30 position only is desired, proceed directly to paragraph f, page
d i s p l ay
data by
latitude and
4 - 6 4 .
If both 20 and 3D positions are desired, the initial
of the 3D position is accessed at the completion of the 2D
pressing the enter (E) key when the standard deviation of
longitude is on display.
Displav 2D position .
If desired. the 2D position should
then recorded on DA
( 1 ) P r e s s c
Form 1959.
Display 2D position as follows:
ear (C) key and key in code 53.
be displayed and
NOTE
The following data is in terms of satellite datum.
If datum conversion
is required refer to paragraph 4-6.3.4, page 4-98.
( 2 ) P r e s s t h e e n t e r ( E ) k e y t o r e a d t h e i n i t i a l d i s p l a y , t h e n p r e s s t he
enter (E) key to erase and view each successive display in turn.
I n t e r p r e t t h e
displayed data in accordance with Table 4-5.
Change 2
4-61
