TM 5-6675-318-14
(45) Press clear key and when CODE is displayed, enter code 41.
( 4 6 ) C l o s e t a p e c a s s e t t e t r a n s p o r t c o v e r b y p r e s s i n g f i r m l y u n t i l i t l a t c h e s .
d . R e c e i v e r s t a t u s .
NOTE
Enter code 50 to display functional status of MX 1502. Status is
indicated by combination of code numbers and letters.
Receiver status
is shown on left of slash and error codes on right of slash. If
self-test is being performed, TEST is displayed instead of STAT. Explana-
tions of codes are listed below.
Error codes remain until cleared by
s u c c e s s f u l s e l f - t e s t .
( 1 ) P r e s s c l e a r ( C ) k e y.
(2) Key in 50 and press enter (E) key.
Table 4-2.
RECEIVER STATUS CODES
Code
Status
Blank
No signals available.
1
Receiver has acquired only 150 MHz signal.
4
Receiver has acquired only 400 MHz signal.
A
Receiver has acquired 150 and 400 MHz signals.
S
Receiver is searching for or has found particular
s a t e l l i t e t h a t h a s b e e n p r e d i c t e d . U n i t h a s a l e rt
d a t a f o r t h i s s a t e l l i t e .
T
Receiver is tracking satellite. The 2 min message
from satellite has been detected.
4-56
Change 2
