TM 5-6675-318-14
(4) Plug power cord into 120 V ac outlet.
(5) Turn on LINE switch and observe that pilot lamp lights .
(5.1) Adjust COARSE control for CURRENT to fully right.
(6) Adjust COARSE control for CURRENT to fully right.
(7) Adjust COARSE and FINE VOLTAGE controls to between 13 and 13.8 V.
w.
Connect power cable to jack on receiver/processor labeled POWER.
NOTE
Steps x and y are o p t i o n a l .
x .
Connect cable between DATA I/O connector and alphanumeric printer.
y .
Check that printer has sufficient paper and serviceable ribbon.
Change 3
4-43
