TM 5-6675-318-14
Section IV ORGANIZATIONAL MAINTENANCE
8-11.
LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
8-12.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
8-12.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
8-12.2 Special Tools; Test,
Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
8-12.3 Repair Parts.
R e p a i r p a r t s a r e l i s t e d a n d i l l u s t r a t e d in
and Special Tools List, TM 5-6675-318-24P covering organizational
this equipment.
8-13.
SERVICE UPON RECEIPT.
8-13.1
Checking Unpacked Equipment.
a.
Inspect the equipment for damage incurred during shipment.
the Repair Parts
m a i n t e n a n c e f or
If the equipment
has been damaged, report the damage on DD Form 6, Packing Improvement Report. -
b. Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions of DA Pam
738-750.
C.
Check to see whether the equipment has been modified.
8-14. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES. There are no
organizational PMCS procedures assigned for this equipment.
8-15. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES. There are no organizational
troubleshooting procedures assigned for this equipment .
8-16.
MAINTENANCE PROCEDURES.
a.
This section contains instructions covering organizational maintenance
f u n c t i o n s f o r t h e f u r n i t u r e a n d c a b i n e t s.
Personnel
required
are
task requires more than one.
b. After completing each maintenance procedure, perform operational
sure that equipment is properly functioning.
listed
only
if
the
c h e c k t o b e
8-5
