TM 5-6675-318-14
Table 4-21. CODE DESCRIPTIONS - Cont
Code 73, Display Translocation Position
NOTE
This code applies only to Version 100 and above units.
Enter code 73 to display the most recently computed translocation position. The
translocation position computation is based on accumulated data. The translocation
position is displayed in a sequence of 15 displays. Press the enter (E) key to
erase one display and view the next. The initial display shows the following
information:
I n i t i a l D i s p l a y
(1) Translocation code mnemonic (TR).
(2) When this position is blank, the translocation position was computed using
d a t a f r o m t h e l a s t s a t e l l i t e p a s s . A o n e - l e t t e r c o d e i n t h i s p o s i t i o n i n d i c a t es
that the last pass data was not used. The following codes signify the reason for not
using data from the last pass:
0 -
C -
D -
E -
H -
I -
R -
S -
No 2D fix could be computed.
Less than eight doppler counts used in 2D computation.
More than 1 km (0.62 miles) between 2D position and reference position.
Maximum elevation angle of satellite less than 15 degrees.
Maximum elevation angle greater than 70 degrees immediately after 3D
position was reset.
More than six iterations occurred in 2D computation.
Only one of two satellite receiver channels was used to calculate 2D
position due to insufficient data on other channel.
S t a n d a r d d e v i a t i o n o f r e s i d u a l s w a s t o o l a r g e , i n d i c a t i n g t h a t s a t e l l i te
data was in error (see code 91).
4-150
