TM 5-6675-318-14
PLOTTER OPERATION AND PROGRAM ERRORS - Cont
Table 3-21.
Error
Error No.
Explanation
Displayed
PLOTTER ROM ERRORS - Cont
axe, ltr INSTRUCTIONS
EXECUTED
P7
O c c u r s on axe and ltr instructions because ROM recognizes
these instructions but cannot execute them. This error flags
a l l a x e a n d ltr i n s t r u c t i o n s f o r p u r p o s e o f c o n v e r t i n g 9 8 2 5
programs.
CALCULATOR STOP KEY CANCELLED OPERATION
P8
Occurs on any instruction when plotter fails to respond for
three seconds after STOP key has been pressed. This error is
most likely to occur when pen is traveling slowly.
TRANSMISSION ERROR
p0
Computer has received an illegal ASCII input from plotter.
INSTRUCTION NOT RECOGNIZED
p1
Plotter
has received illegal character sequence.
p2
WRONG NUMBER OF PARAMETERS
Too many or t o o few parameters have been sent with instruc-
tion.
BAD PARAMETER
p3
Parameters sent to plotter with instruction are out of range
for that instruction.
ILLEGAL CHARACTER
p4
Character specified as parameter is not in allowable set for
that instruction.
3-212
