TM 5-6675-316-14
3-6.2 Initial Adjustments, Daily Checks and Self Test.
NOTE
l Moving mounting block left engages drive and encoder gears. Moving
mounting block right disengages.
l DSP-2 machine controller can be turned on with power button on X-carriage
or on front of DSP machine controller. Button originally pressed must be
pressed again to reset or turn system off.
a. Press power button on X-carriage or on DSP machine controller.
b.
c.
Mount pen lifting device with ball point pen on X-carriage (table 3-5, items 1 and 3).
Attach piece of drafting paper (36” x 24 “) to center of table surface.
d. Run test tape (paragraph 3-6. 3q). If tape is not available, input test program, shown in “Test Tape
Program Listing” following step f of this procedure, into console or use program to produce tape on teletype
(paragraph 3-6. 3n).
Change 1
3-55
