TM 5-6675-316-14
(11)
(12)
(13)
Unlock X- and Y-carriages. Manually move tool over perimeter of drafting surface and across center while
watching tool point. If necessary, adjust height of tool by turning knob at top of tool holder.
Turn on fluorescent lamps and XY display. Check that display changes when each carriage is moved. If XY
display does not operate correctly, refer to troubleshooting.
Engage drive motors on each carriage by loosening locking lever, moving motor gear against encoder
gear, and locking latch.
3-54
Change 1
