TM 5-6675-316-14
(21 ) Reinstall Y-rail front end plate and front rubber stop.
NOTE
Turn Y-carriage bearing adjusting left until they just begin to loosen. Turn X-
carriage bearing adjusting screws right until they just begin to loosen.
(22) Move Y-carriage forward and reset X- and Y-carriage bearings.
(23) Mount fine adjustment device on Y-rail. Attach to Y-carriage by lifting stop pin, sliding tool shaft in, and
dropping stop pin into hole in top of tool shaft.
(24) Reinstall X-rail end plate and end rubber stop.
(25) Reinstall Y-carriage left side cover.
Change 1
3-47
