TM 5-6675-316-14
(12) Disengage X-carriage drive motor by loosening locking lever and moving motor back. Then lock motor
into place.
(13) Perform before operation PMCS (table 3-2, item 2).
(14) Perform lubrication (paragraph 3-8).
CAUTION
. When mounting X-carriage, do not attempt to force in place or damage to gears and rack will result.
. Be sure that limit switch cams are held back so they do not catch on trip dogs or damage to cams could
result.
l When front set of bearings are on rail, pull against motor mount to hold pinion gear away from
rack to prevent possible damage.
l Be sure ribbon cable is not twisted when installing X-carriage or equipment damage may occur.
3-44
Change 1