TM 5-6675-316-14
(15) Lift X-carriage with both hands and slide onto X-rail with end plate removed. After carriage is initially set
on X-rail, hold cams of limit switches back before pushing carriage further so they are not caught on trip
dogs.
(16) Mount fine adjustment device on X-rail and tighten. Attach to X-carriage by lifting stop pin, sliding in tool
shaft, and dropping stop pin into hole in top of tool shaft.
(17) Reinstall bottom back cover on X-carriage.
(18) Reinstall X-carriage tensioning device. Be sure that the set screw is up.
Change 1
3-45
