TM 5-6675-316-14
c.
Remove
d. Remove
e.
Remove
digitizing
ribbon cabl
system card cage cover.
e from PC board if required.
defective PC board(s) with card puller.
NOTE
Be sure cards are fully seated.
f. Install new PC board(s) carefully to avoid component damage.
9.
Reinstall card cage cover and side panel.
h. Plug in power
3-20.10 Replace Encoder.
cord.
MOS: 35E, Special Electronic Devices Repairer
TOOLS :
Flat Tip Screwdriver
2 mm Hex Head Key Wrench
7/64 in. Hex Head Key Wrench
SUPPLIES: Encoder
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
a.
Unplug drafting table power cord.
b. Remove socket head capscrews and carriage cover.
3-164
