TM 5-6675-316-14
e.
f.
9.
h.
i.
j.
k.
Loosen three retaining screws.
Rotate encoder holding tabs to clear encoder
Hold gear and remove encoder.
Install new encoder while holding gear.
Rotate gear until shaft socket head capscrew
hole and then tighten screw.
Position encoder holding tabs in groove.
Tighten screws.
l.
Reconnect encoder cable and tighten.
m.
Reinstall carriage cover.
n.
Plug in power cord.
groove.
is seen through access
3-166