TM 5-6675-316-14
Section Ill OPERATOR MAINTENANCE
3-8. LUBRICATION INSTRUCTIONS.
NOTE
These lubrication instructions are mandatory.
3-8.1 Bearing Support Runners.
Prior to use, put several drops of mineral oil
(Item 16, Appendix E) on clean cheesecloth (Item 6, Appendix E) and wipe down
bearing support runners on both table rails.
3-9. TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions which you may find during operation
or maintenance of the combined drafting and measuring machine or its components.
You should perform the test/inspections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions.
If a malfunction is not listed or is not
corrected by listed corrective actions, notify your supervisor.
3-126
