TM 5-6675-316-14
f. Reinstall all side panels and turn retaining screws one-half turn to right.
g. Disconnect ground wire, encoder wire, and XY display wires from table frame
CAUTION
When removing X and Y carriage system for movement, handle ribbon cables
with care or damage may result.
NOTE
l When preparing X- and Y-carriages for movement, it is not necessary to
remove ribbon cables.
l Some steps in this procedure require two persons to perform.
h. Remove Y-rail front end plate and rubber stop.
i. Disengage X-carriage and lock in place with fine adjustment device.
j. Disengage Y-carriage and remove Y-carriage with X-carriage attached and set on floor in area of tiedowns.
k. Reinstall Y-rail front end plate and rubber stop.
1. Remove plate and rubber stop from left end of X-rail.
Change 1
3-121
