TM 5-6675-316-14
(5) Adjust tension for scribe point as follows:
(a)
(b)
(c)
(d)
(e)
Position scrap scribe material on drafting surface and secure with tape.
Run short tape (1 or 2 lines).
Check scribing for clean smooth lines.
Adjust tension as necessary.
Repeat steps (a) through (d) above until desired result is achieved.
CAUTION
When using machine in automatic mode with drive motors engaged, do not
attempt to move carriages by hand or damage to gears and encoder will result.
(6) To control scribing operation, use operator’s console to input drafting commands (paragraph 3-6.3s) or
run program tape on machine controller (paragraph 3-6.3q).
3-6.4 Preparation for Movement,
a. Place all accessories in accessory case and store in cabinet drawer.
b. Install tiedowns in the tiedown sockets
Change 1
3-119
