TM 5-6675-316-14
Table 2-3. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
16. NO POWER TO MACHINE.
Step 1.
Check that power switch is in ON position.
(a) If power switch is on, proceed to step 2.
(b) Turn power switch on.
Step 2.
Visually check main power fuse.
(b) If problem is not corrected, refer to direct/general support
maintenance.
2-10. MAINTENANCE PROCEDURES.
This section contains instructions covering operator maintenance functions for
the composing machine. Personnel are listed only if the task requires more than
one.
b. After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
INDEX
PARAGRAPH
PROCEDURES
Replace Main Power Fuse... . . . . . . . . . . . . . . . . . . . . .2-10.1
2-138