TM 5-6675-315-14
2-35.11 Remove/Install Shredder-Bagger.
MOS: 83FJ6, Reproduction Equipment Repairer
PERSONNEL: Three persons are required to perform this procedure
TOOLS: Flat Tip Screwdriver
15/16 in. Combination Wrench
1/2 in. Combination Wrench
12 in. Adjustable Wrench
Jewelers Screwdriver Set
SUPPLIES: Shredder-Bagger
Electrical Tape (Item 21, Appendix E).
WARNING
Death or serious injury may occur from electrical shock unless power is off before servicing.
a.
Turn off circuit breaker.
b.
Lower rollers on all four corners of machine by turning roller lowering bolts until rollers contact floor.
CAUTION
To prevent equipment damage, be sure that all four corner rollers contact floor before removing
mounting bolts from air shocks.
c.
Remove mounting bolts and washers from air shocks.
d.
Deflate air shocks and remove spacers.
e.
Open front panel.
f.
Remove screw on main power switch knob and cover.
g.
Remove ground wire.
h.
Remove screws and housing retaining cover.
i.
Push main power switch wiring assembly through cabinet to outside of machine.
2-224
