TM 5-6675-315-14
NOTE
Timer relay in relay box determines cycle time of press ram. This relay is factory preset between
10 and 180 seconds and sets amount of time available to shred material before press ram begins
to move forward.
(5)
Feed material until ram cycle time is up and the press ram begins to compress material. Wait until press
ram has made one cycle and returns to start position. Then feed material again.
(6)
When bale chamber full lamp lights, bale compartment is full. Eject bale and install new bag.
c.
Eject bale.
WARNING
Dangerous equipment hazard. Keep fingers and hands away from bale chamber while press ram
is moving. Remove all rings, watches, ID tags, or any other jewelry. Serious personnel injury
could result from failure to observe this safety precaution.
(1)
Pull back on safety lock holding clamp arm in position.
2-179
