TM 5-6675-315-14
(8)
Be sure that cylinder crossblade is visible.
(9)
Slide bale down backboard. Tie or band up top of bale.
(10)
Press yellow ram reverse switch until press ram begins to move rearward.
NOTE
If power is lost while press ram is moving, yellow return switch must be pressed to get ram to
move after power is restored.
(11)
When press ram has returned to start position, push any shreds that fell out of bale back in chamber.
(12)
Install a new plastic bag and reconnect backboard, pressure plates, and rear gate (paragraph 2-6.1).
2-6.3 Preparation for Movement. Inflate air shocks in accordance with paragraph 1-6.2.
2-37
