TM 5-6675-315-14
NOTE
The press ram cycles automatically when cutter FORWARD switch is activated. If only small
portion of material is to be shredded, be sure that press ram has cycled at least once before
stopping blades. If cutter mechanism is shut off or power is lost while press ram is moving, ram
can only be reactivated by pressing rear safety switch SSP with power on.
NOTE
Timer relay in relay box determines cycle time of press ram. This relay is adjusted between 10
and 180 sec and sets amount of time available to shred material before press ram begins to move
forward.
(4)
Feed material until cycle time is up and the press ram begins to compress material. Wait until press ram
has made one cycle and returned to start position. Then feed material again.
NOTE
•
If cutter mechanism is overloaded with material, cutter safety switch on back of shredder-
bagger will trip and stop blades. To restart, go to rear of shredder-bagger, clear away as
much material as possible, and then press cutter REVERSE switch.
•
If cutter is to be operated for extended period of time, apply oil to gears once an hour by
pulling on oiler handle.
(5)
When cycle stop lamp lights, bale compartment is full. Eject bale and install new bag.
2-33
